The cell pellets were resuspended in 50 ml VMM with pH 5.75 and 50 ml VMM with pH 7.0, respectively, and incubated at 30°C. At six time points
cell suspension probes of 5 ml were harvested from each flask. Immediately centrifuged (10000 × g, 1 min, 4°C) the resulting pellets were instantly frozen by liquid nitrogen for later RNA preparation. Cell suspension probes were harvested at 3, 8, 13, 18, 33, and 63 minutes following the pH shift. RNA isolation RNA was isolated according to the protocol published by Rüberg et al. [14]. Total RNA was prepared using the RNeasy mini kit (QIAGEN, Hildesheim, Germany). By ribolysation (30 s; speed, 6.5; Hybaid, Heidelberg, Germany) cells were disrupted in the RLT buffer provided with the kit in Fast Protein Tubes (Qbiogene, LY2109761 Carlsbad, CA). Transcriptional profiling using the SM6kOligo whole genome LY3023414 solubility dmso microarray The well established Sm6kOligo microarray described by Krol and Becker [15] was employed for transcriptional profiling. For each preparation of Cy3 and Cy5 labelled cDNAs 10 μg of total RNA were used [69]. To each microarray the cDNA of the pH 7.0 and pH 5.75 grown cultures were mixed and hybridised. The microarray experiments were performed in three biological replicates. The acquisition
of the microarray images was performed as described previously [14, 15]. By using the ImaGene 5.0 software (Biodiscovery Inc., Los Angeles, CA, USA) the mean signal and mean local background intensities for each spot were identified and calculated. very If R was ≤ 1.5 in both channels, spots were flagged as “”empty”", the remaining spots were used for further analysis. The log2 value of the intensity ratios (Mi) was calculated for each spot with Mi = log2(Ri/Gi). Ri = Ich1(i)-Bgch1(i) and Gi = Ich2(i)-Bgch2(i) with Ich1i and Ich2i being the intensities of a spot in channel l or channel 2 and Bgch1(i) and Bgch2(i) being the background intensity of a spot in channel 1 or channel 2, respectively. The mean intensity was calculated for each spot with Ai = log2(RiGi)0.5. Normalization and t-statistics were carried out using the Emma
1.1 microarray data analysis software [26]. It should be mentioned that in this work genes with a positive M value are addressed as “”up-regulated”" and genes with a negative M value are addressed as “”down-regulated”", although a positive value will also be calculated if a gene is less strong down-regulated under pH 5.75 than under pH 7.0 and vice versa. The microarray results were verified for specific genes (lpiA and phoC) by quantitative reverse transcription-PCR using a QuantiTect SYBR Green reverse transcription-PCR kit (QIAGEN, Hildesheim, Germany) according to the manufacturer’s instructions. Filtering and clustering analysis of the microarray data For clustering Selleck Torin 1 purposes only those genes were taken into account which had an evaluable expression value for at least 5 of 6 time points and for which at least one time point had an M value of ≥ 2 or ≤ 2.