1. Extrusion parameters were feed moisture content of 25% (dry basis), screw speed of 200 rpm, feed rate of 100 g/min and die diameter of 3.0 mm. The temperature profile from feed section to die exit was set to 50°C/110°C/110°C. The extrudate was dried directly in an air oven at 60°C

for 8 hours, and ground in a laboratory grinder to pass through a 400-μm sieve, then stored in plastic bags for further analysis. Moisture content, crude fat, protein, and ash were analyzed by the standard methods described in the Official Methods of Analysis of the Association of Official Analytical this website Chemists (AOAC) [12]. Total sugar and reducing sugar contents were determined according to the phenol–H2SO4 and dinitrosalicylic www.selleckchem.com/products/Bosutinib.html acid (DNS) methods, respectively [13] and [14]. The expansion ratio was determined by dividing the diameter of the extrudate by the diameter of the die (3 mm). The specific length was

evaluated as the straight length divided by the weight of extrudates. A total of 10 readings were recorded for each sample. Bulk density was determined after the extrudates were cut into pieces of approximately 2 cm in length by using a seed displacement method [15]. The color of the extrudate was measured with a colorimeter (CR-300; Minolta, Osaka, Japan). Color parameters L, a, and b were recorded separately. Water solubility index (WSI) and water absorption index (WAI) were measured by the modified method of Anderson et al [16]. A 1.5 g sample was dissolved in 30 mL of distilled water and shaken in the thermostatic water bath at 30°C for 30 minutes, and then centrifuged at 1000 × g for 10 minutes. The supernatant was decanted into a preweighted evaporating dish. The weight of the sediment

selleck chemicals was taken as WAI and was expressed as the unit g/g. The WSI is the weight of dry solids in the supernatant, which is expressed as a percentage of the original weight of the sample. Measurements were performed in triplicate for each sample. The dispersibility of the ginseng sample powder was determined according to the method of Shin et al [17] with minor modification. One gram of the ginseng powder was mixed with 30 mL distilled water. It was then shaken 10 times by hand and was left standing. The dispersion state after 10 minutes was observed and evaluated. Mechanical properties were determined with a Sun Rheometer (Compac-100; Sun Scientific Co., Ltd., Tokyo, Japan) equipped with a 2-kg load cell. The cross-head speed was set at 60 mm/minute. Ten replicates of extrudate were randomly selected and a mean value was recorded. The microstructure of extruded sample was examined with a field emission scanning electron microscope (MIRA II LMH; Tescan USA Inc., Cranberry Township, PA, USA). The accelerating voltage of scanning electron microscope was 10.0 kV. Crude saponin contents were determined according to the water-saturated n-butanol extraction method of Park et al [18] with some modification.