After a brief cycling warm up, the subjects completed a warm up set consisting of 10 repetitions at 50% of the actual load to be used during the work sets. After a two min rest period the subjects performed the second warm up set at 80% of the load to be used during the work sets. After a three min rest period, subjects completed six sets, separated by 2 min rest periods. The subjects were instructed to lower the barbell under control (eccentric) and then verbally

encouraged to “drive” the barbell upwards in as short as time possible (concentric). The squat training session lasted NVP-BSK805 order ~18 min. After the completion of each set the subjects were also asked their rate of perceived exertion (RPE) using the Borg scale [32]. Five microliter (μL) finger tip capillary blood samples were collected Torin 1 manufacturer under standard

aseptic procedures before, immediately after and twenty min post-exercise to analyse blood lactate (LT 1710 Lactate Pro, KDK Corporation, Shiga, Japan). An integrated linear force transducer (Gymaware system, Kinetic Performance Technology, Canberra, Australia) was used to determine barbell displacement for each repetition and set completed. This system allows for the determination of concentric mean power (W), and concentric velocity (m·s) to be determined. The system was set up according to the manufacturer’s guidelines and has been shown to provide a reliable (Coefficients of variation (CV) = 3.3%) and valid estimate of power during resistance training [33]. Blood collection and analysis Venous blood was withdrawn via venepuncture before, immediately after and twenty min after the HTS. Blood was collected

from a vein in the cubital fossa in ethylenediaminetetraacetic acid (EDTA) (10 ml tube) vacutainers (BD367863, NJ, USA). The samples were then centrifuged at 3000 rpm for 10 min, at 4°C. The plasma top layer was placed into Eppendorf tubes (Oldenburg, Germany) and snapped frozen and stored at −80°C until analysis. Plasma GH, an indicator Pyruvate dehydrogenase of the anabolic hormonal milieu during RT [34] was determined pre-exercise, immediately post-exercise and 20 min post-exercise. Plasma GH was VS-4718 molecular weight assayed by a radio-immunoassay using a commercially available kit (human growth hormone ELISA DSL-10-1900, Diagnostic Systems Laboratories, Webster, USA). The assay was performed in duplicate as per the instructions from DSL and determined the levels of the 22 kDa GH isoform. The CV was less than 7% for the assays and the limit detection was 0.03 ng/ml. Plasma cortisol (CORT) was measured as an indicator of the catabolic hormonal environment during RT [34], and was determined by a radio-immunoassay using a commercially available kit (cortisol ELISA DSL-10-2000, Diagnostic Systems Laboratories, Webster, USA).