selleck compound Caco-2 cells (ATCC HTB37) were cultivated in Dulbecco’s Modified Eagle’s Medium (DMEM) supplemented

with Glutamax (Gibco), 10% fetal bovine serum (Greiner Bio-One, Wemmel, Belgium), 1% non-essential amino acids and 2% penicillin/streptomycin + 2.8 μg/ml amphotericine B (fungizone) at 5% CO2 in air. Before the experiment, 88.000 cells/cm2 were seeded on glass slides covered overnight with rat-tail collagen of type I (BD Biosciences, Belgium) and grew till confluence [52]. After 7 days of culture, the cells were ready to be challenged with bacteria. During the experiments, the cells were maintained in the same medium but without antibiotics and antimycotics to avoid killing the bacteria growing in the upper chamber. Characterization of the technical parameters www.selleckchem.com/products/prt062607-p505-15-hcl.html Hydrodynamics studies (computational fluid dynamics) were carried KU-57788 solubility dmso out by means of Fluid 6.0 CFD software (ANSYS, Canonsburg, USA) [53]. The aim was to evaluate

the best design for generating a homogeneous flow within the compartments under different shear forces representative of the upper and distal small intestine and of the colon (i.e. 25, 12 and 2 dynes cm−2, respectively). The adhesive capacity of the mucus layer to the polyamide membrane was evaluated by means of CLSM. Two HMI modules were set up and fluorescein isothiocyanate (FITC) dextran (4 KDa), a fluorescent compound, was added to the mucin/agar layer in order to make the mucus visible by CLSM. The integrity of the mucus layer (200 μm) was analyzed after a 5-hour incubation period under either medium or high shear stress (i.e.

10 and 20 dynes/cm2). Data were calculated as percentage of residual find more mucus (after 5 h) on the membrane as compared to Time 0, analyzing a vertical section of the functional double layer. In a separate experiment, three HMI modules were set up to evaluate the permeation of metabolites of different dimensions and molecular radius through the double functional layer by means of a water solution containing FITC conjugated dextran of 4, 20 and 150 kDa, as model compounds. The permeability of the polyamide membrane was assessed with and without a 200 μm mucus layer and at a constant flow of 6.5 mL min−1. A standard curve based on the molar concentration was created for each compound. Measurement of the fluorescent compounds (collected from the lower compartment) at an excitation wavelength of 485 nm and an emission wavelength of 530 nm and calculation of the permeability coefficient (Pc) was conducted as reported in Ambati et al. [54], using the following equation: where C3.5 and C0.5 were the concentration of the FITC dextran in the lower compartment at 3.5 h and 0.