However, random surface roughness and metal islands induce scattering on both structured and flat surfaces and thus deteriorate functioning of plasmonic devices [7–9]. It was shown in experiments that surface plasmon losses in various plasmonic

structures are virtually insensitive to temperature change. A PMMA/Ta2O5/Au multilayer on glass substrate has almost the same transmission spectrum at wavelength range 550 to 800 nm measured in temperatures from 80 to 350 K [10]. The decrease of electrical resistivity of silver with the reduction of temperature does not influence eFT508 supplier the surface plasmon loss. The imaginary part of electric permittivity of silver, which is inversely proportional to the ohmic

conductivity, changes with temperature but depends mostly on the silver film thickness. Thus, it is not the ohmic losses due to electron scattering in silver but the temperature-independent morphology of the silver surface that decides on losses due to scattering into free space [2]. The above conclusion is in agreement with recently observed maxima in the visible range of the transmittance spectra of Ag/MgF2/Ag [11], Ag/ITO/Ag [12], and ZnO/Ag/ZnO [13] multilayers, which clearly depend on Ag surface morphology. Heteroepitaxial deposition of ultrasmooth noble metal layers on ATM Kinase Inhibitor research buy crystalline or glass substrates is described with one of two ideal growth find more manners. In the Frank-van der Merwe deposition mode, the process begins with atom-thick islands, which dilate, connect, and eventually these form

continuous layers. In the Stranski-Krastanov (SK) growth, after the first few layers are formed, the nucleation of island begins because of strains and diffusivity of adatoms. In electron beam deposition processes, an atom evaporating from a hot crucible (about 1,200 K) arrives onto a substrate kept at room temperature (RT) and slowly loses its kinetic energy. Diffusivity of metal adatoms on the surface diminishes with decreasing substrate temperature. Thus, cooling the substrates to cryogenic temperatures should in principle lead to ultrasmooth layers. The role of surface diffusivity of Ag adatoms in the formation of islands and then grains was demonstrated by Jing et al. in STM measurements, where with increasing layer thickness the silver clusters were more and more pronounced [14]. The same authors observed that deposition of 12 monolayers of silver at 190 K results in an increase of island densities by 4 orders of magnitude in comparison to that obtained at RT. At the same time, silver atom clusters were at least 1 order of magnitude smaller. The diffusivity of Ag adatoms is reduced with an amorphous 1-nm Ge interlayer [15–17], 5-nm layer of chromium [18], or 1-nm film of Ti [19].